Home > Accessories > Belt Mod Kits
(Details shown apply to the default selection)
Model: rowan_heq5_pinion_extractor_3mmPart Number: 10100012aa
An optional extractor tool to easily remove the pinion gear from the motor when fitting the Rowan HEQ5 Belt Mod Kit.
Choose the extractor size for the pinion through hole diameter. Please measure the diameter shown in the photo below.
The measurement will be 3mm or 4mm. 4mm type shown.
(In over 90% of cases, 3mm is required).
A must if you are removing the pinion for the Rowan belt upgrade. I used the 4mm. I think it should be made part of the Rowan kit as not sure how I would have removed it without it.
Done the job perfectly would’ve struggled without it
An essential tool to easily do the skywatcher heq5 pro belt mod.
My first order. Good service. Extraordinary catalog of products. Added as new supplier.
Not sure if I were able to extract the pinion without this tool. I got the 4mm for my Sirius. Works like a charm!
This little piece of equipment was so easy to use and and as a non-engineer I guess it kept my blood pressure under control. I vital extra.
I just can't imagine I would be able to complete the belt mod had I not get this extractor.
I recommend this small thigs everyone who buy the belt mod. In my case one of the gear was stuck on the shaft very hard. That was a bit challange to remove with pinion extractor too. I can't magine what happened without it...
First Light Optics LtdUnit 7 Budlake UnitsBudlake RoadMarsh Barton Trading EstateExeter, DevonEX2 8PY
Company No. 5892293VAT No. 907 2895 01
First Light Optics Ltd All rights reserved © 2023