About this product
Part Number: FLAP170-168-145_WO_FLT132
Making flats can be cumbersome, especially if not part of an automated routine. The DAD flap panel makes making flat frames a lot easier.
While you image, the flap panel is tucked neatly alongside the refractor tube. When you finish, flip it into place and turn on the dimmable LED light.
You can adjust brightness according to your camera responsiveness/gain settings and filters.
For those operating in high humidity conditions, the DAD can also be purchased with an integral heater, to keep dew at bay.
- ASCOM supported
- INDI supported
- LED brightness control
- 270-degree range of motion
- Built-in heater (optional)
- Lightweight (300g)
NOTE: Power adapter not included.
What's in the box
- Flap Panel 1
- OPTIONAL: Flap Panel Heater
- OPTIONAL: 5.5mm x 2.1mm MALE-MALE cable (25cm)
- OPTIONAL: 5x5mm x 2.1mm MALE-MALE cable (50cm)
Please fill in the form below to ask a question.