About this product
Model: iop_mini_pier_8032
Part Number: 8032
iOptron® MiniPier is designed for iOptron GOTO mounts to provide 8" extra telescope height.
Fits on various iOptron tripods/piers.
Can also be used with other tripods & piers, with a little DIY...
The MiniPier fits these iOptron tripod/pier
- LiteRoc Tripod for AZ Mount Pro, CEM60/70
- MiniTower 1.5" Tripod
- MiniTower 2" Tripod
- AZ Mount Pro Tripod
- iEQ45/CEM60 Tripod
- 48-inch Pier (#8030) and 42-inch Pier (#8033)
- Tri-Pier (#8034)
- DO NOT fit on iEQ30 Tripod
The following mounts can be mounted onto the MiniPier:
- CEM70
- CEM60
- CEM40/GEM45 (won't fit on CEM40/GEM45 tripod, may limit low latitude application)
- HAE43/HEM44 (may limit low latitude application)
- iEQ45/iEQ45 Pro
- iEQ30/iEQ30 Pro (won't fit on iEQ30 tripod, may limit low latitude application)
- AZ Mount Pro/MiniTower/MiniTower II/MiniTower Pro
- Other mount with #8036 adapter
(*Not all accessories shown here are included. Contact us if you are not sure what else you may need)
Specifications
Pier Diameter | Ø5.7" (Ø144 mm) with 150mm top plate |
Height | 8" (200 mm) |
Downloads / Manuals
Manual
Assembly Instruction
Pier Top Plate Drawing
Customer reviews
Average Rating (3 Reviews): | |
17 March 2024 | Allan
An excellent pier to heighten the tripod, especially if you are considering using a refractor telescope. The only problem I faced with the mini pier was the adjusting, leveling screws, fitting into the pier. The threads on the pier was so tight that I had to brush out dust and some paint to make them fit. They still are tight, but workable with a little drop of oil. Reason for 4 stars.
FLO excellent, mini pier not so great 14 November 2023 | Michael
Bought this for my CEM40 mount, and not long after first use, I notice a bit of wobble in the scope & mount head. Tracked it down to the relatively lightweight fixings holding the top plate to the cylindrical pier tube. I think this is an iOptron design issue, as I had the same problem with the pier-top on the CEM70 tripod. Anyway, it can be remediated if you use a tap to cut the 3 fixing bolt & threads out to a larger diameter bolt which are better suited to the job. I see iOptron have now released a different pier-head design for several of their mounts. I'd avoid this and go for those if the reviews are good.
Note: FLO were happy to swap out the pier, but I figured a replacement would have the same issue, so opted for fixing it myself.
13 March 2023 | Christopher
Superb addition to the AZ Mount Pro, wonderful quality
FAQ
Please fill in the form below to ask a question.