About this product
Part Number: 10100012a
An optional extractor tool to easily remove the pinion gear from the motor when fitting the Rowan HEQ5 Belt Mod Kit.
Choose the extractor size for the pinion through hole diameter. Please measure the diameter shown in the photo below.
The measurement will be 3mm or 4mm. 4mm type shown.
(In over 90% of cases the 3mm is required).
|Average Rating (3 Reviews): |
Friday, 14 June 2019 | David
This little piece of equipment was so easy to use and and as a non-engineer I guess it kept my blood pressure under control. I vital extra.
Tuesday, 28 May 2019 | Ming
I just can't imagine I would be able to complete the belt mod had I not get this extractor.
Wednesday, 6 March 2019 | Attila
I recommend this small thigs everyone who buy the belt mod. In my case one of the gear was stuck on the shaft very hard. That was a bit challange to remove with pinion extractor too. I can't magine what happened without it...
Please fill in the form below to ask a question.